Setting Add/Delete/Blank - Zenith Concierge H27D35DT Installation & Operating Manual

Setting Add/Delete/Blank

Fine-tune the guest's channel selection list
1
Press the MENU key on the Installer's remote so the Setup
menu appears.
2
Press SELECT repeatedly to highlight the Add/Del/Blnk
option.
3 Using either the NUMBER keypad and ENTER or the
Channel Up/Down arrow on the remote, select a channel.
(If adding a deleted channel, you will need to use the
NUMBER keypad and ENTER.)
4
Using the Right/Left ADJ arrow, pick whether that channel
is Added, Deleted, or Blank.
To continue, select another channel and repeat Step 3.
5
When you are finished, press ENTER to remove menu.
Adding Aux, VCR 3, VCR 4, to the Channel
Preview List
Go to the Setup menu, select the Add/Del/Blnk option.
Use Channel Up/Down to select the option and choose
Added.
Note: If the option was turned off in the Service menu,
you will have to reinstate it before it can appear as an
option in the Channel Preview list.
Notes: Adding VCR 3 and/or VCR 4 as available channels
forces TV Channel 3 and/or 4 to be retained, when run-
ning Auto Program, even though the equipment connected
to the Antenna/Cable (RF) jack (like a cable converter
and/or VCR) may be turned off.
You can elect to Add, Delete or Blank: VCR 3, VCR 4, and
Aux.
If you delete a channel, it isn't gone for good. Just select it using
the NUMBER keypad on the remote, or add it later.
Mini glossary
ADD Adds new channels to the list that the guest can scroll through when using the remote.
DELETE Removes channels for one reason or another from the list that the guest can scroll through.
BLANK Removes the video signal from a channel so the guest will only receive the audio signal.
206-3489-A
CH 44 ADDED
2
1
4 5
3
7 8
0
ENTER
TIMER MENU
SELECT
2
ADJ
4
3
3
6
9
3/5
1
ALARM
CH PREVIEW
ADJ
P A G E 1 7