Setting Add/Delete/Blank - Zenith HealthView H20C50DT Installation And Operating Manual, Warranty

Setting Add/Delete/Blank

Fine-tune the patient's channel selection list
1
Press the MENU key on the Installer's remote so the Setup
menu appears.
2
Press SELECT repeatedly to highlight the Add/Del/Blnk
option.
3
Using either the NUMBER keypad and ENTER or the
Channel Up/Down arrows on the remote, select a chan-
nel.
(If adding a deleted channel, you will need to use the
number pad and ENTER.)
4
Using the Right/Left ADJ arrows, choose whether that
channel is Added, Deleted, or Blank.
5
To continue, select another channel and repeat Step 3.
When you are finished, press ENTER to remove menu.
Adding Aux, VCR 3, VCR 4, or FM to the
Channel Preview List
Go to the Setup menu, select the Add/Del/Blnk option.
Use Channel Up/Down to select the option and choose
Added.
Note: If the option was turned off in the Service menu,
you will have to reinstate it before it can appear as an
option in the Channel Preview list.
Notes: Adding VCR 3 and/or VCR 4 as available channels
forces TV Channel 3 and/or 4 to be retained, when run-
ning Auto Program, even though the equipment connect-
ed to the Antenna/Cable (RF) jack (like a cable convert-
er and/or VCR) may be turned off.
You can elect to Add, Delete or Blank: VCR 3, VCR 4,
and Aux. FM can be Added or Deleted, but not Blanked.
If you delete a channel, it isn't gone for good. Just select it
using the NUMBER keypad on the remote, or add it later.
Mini glossary
ADD Adds new channels to the list that the patient can scroll through when using the remote.
DELETE Removes channels for one reason or another from the list that the patient can scroll through.
BLANK Removes the video signal from a channel so the patient will only receive the audio signal.
206-3491-O
POWER
1 2
3
4 5
7 8
0
BED 1
TIMER MENU
2
SELECT
ADJ
4
CH 44 ADDED
3
3
6
9
ENTER
3/5
BED 2
1
BANK
CH PREVIEW
ADJ
P A G E 1 5