Zenith Concierge H27D35DT Installation & Operating Manual page 7

Hook Up Your Antenna to the TV
Connect an off-air antenna to the TV
1
Locate the Antenna/Cable jack on the back of the TV.
2
Connect the antenna wire that runs from the wall
directly to this jack, according to one of the diagrams
to the right.
3
Remove the back of the remote and put in two AA
batteries.
4
Plug in the TV. Do not plug it into a switched outlet.
The TV is designed to operate on standard current,
120-volt 60 Hertz AC. Do not attempt to operate it
on DC power.
120 V AC
60 Hz
5
Go to page 12 to Auto Program the TV.
If you have a 75 ohm RF cable, then you don't need
any adapters!
A 300 to 75 ohm adapter is not included with the
Zenith TV.
Mini glossary
75 OHM RF CABLE The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded jack on the back of your TV.
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws
300 TO 75 OHM
on one end and a round opening with a wire sticking out on the other end.
ADAPTER
206-3489-O
Back of
Remote
TV Back
Antenna
Flat Wire
(300 ohm)
M.P.I.
TV Back Connections Panel
300/75 ohm (Expanded View)
Adapter
TV Back
Antenna
RF Coaxial Wire
(75 ohm)
M.P.I.
TV Back Connections Panel
(Expanded View)
VIDEO MATRIX
IN OUT
R- AUDIO- L
IN
VIDEO MATRIX
IN OUT
R- AUDIO- L
IN
P A G E 7