Hook Up Antenna And Vcr To The Tv - Zenith Concierge H27D35DT Installation & Operating Manual

Hook Up Antenna and VCR to the TV

Connect an off-air antenna and VCR to the TV
1
Locate the Antenna/Cable In jack on the back of
the VCR.
2
Connect the wire that runs from the antenna,
according to one of the diagrams to the right. As
required, make the other connections as shown to
the right.
3
Remove the back of the remote, put in two AA bat-
teries.
Plug in the TV. Do not plug it into a switched out-
4
let. The TV is designed to operate on standard cur-
rent, 120-volt 60 Hertz AC. Do not attempt to oper-
ate it on DC power.
120 V AC
60 Hz
5
Go to page 12 to Auto Program the TV.
No A/V cables are included with the Zenith TV.
Without A/V cables, most VCRs will not play
videocassettes in stereo sound.
206-3489-O
Back of
Remote
Antenna
TV Back
MATRIX
VIDEO
IN OUT
M.P.I.
R- AUDIO- L
IN
TV Back
Connections Panel
(Expanded View)
Antenna
TV Back
MATRIX
VIDEO
IN OUT
M.P.I.
R- AUDIO- L
IN
TV Back
Connections Panel
(Expanded View)
VCR Back
Flat Wire
(300 ohm)
VCR Back AV panel
output
In
switch
Out Audio
300/75 ohm
Adapter
A/V cables
not included
with TV
VCR Back
VCR Back AV panel
output
In
switch
RF Coaxial Wire Out Audio
(75ohm)
A/V cables
not included
with TV
P A G E 9
3 4
Video
3 4
Video