Steps
1. Disconnect the coin-cell battery cable from the connector on the system board.
2. Peel the tapes securing the coin-cell battery cable to the right I/O-board and palm-rest assembly.
3. Peel and lift the coin-cell battery off the palm-rest assembly along with its cable.
4. Disconnect the coin-cell battery from the coin-cell battery cable.
Installing the coin-cell battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the coin-cell battery and provides a visual representation of the installation procedure.
Steps
1. Connect the coin-cell battery to the coin-cell battery cable.
29