Table of Contents
Advertisement
Steps
1. Using the alignment posts, place the left speaker on the palm-rest assembly.
NOTE: Ensure that the alignment posts are threaded through the rubber grommets on the speaker.
2. Route the speaker cable through the routing guides on the palm-rest assembly.
3. Using the alignment posts, place the right speaker on the palm-rest assembly.
NOTE: Ensure that the alignment posts are threaded through the rubber grommets on the speaker.
4. Connect the speaker cable to the right I/O-board.
Next steps
1. Install the battery.
2. Install the
2230 solid-state
3. Install the
2280 solid-state
4. Install the
base
cover.
5. Follow the procedure in
System board
Removing the system board
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
2230 solid-state
4. Remove the
2280 solid-state
5. Remove the
rear
I/O-cover.
6. Remove the battery.
7. Remove the
right
I/O-board.
38
drive. (if applicable)
drive. (if applicable)
After working inside your
Before working inside your
drive. (if applicable)
drive. (if applicable)
computer.
computer.
Advertisement
Table of Contents
