Table of Contents
Advertisement
2. Adhere the coin-cell battery into its slot on the palm-rest assembly.
3. Adhere the tapes securing the coin-cell battery cable to the right I/O-board and palm-rest assembly.
4. Connect the coin-cell battery cable to the connector on the system board.
Next steps
1. Install the battery.
2. Install the
2230 solid-state
3. Install the
2280 solid-state
4. Install the
base
cover.
5. Follow the procedure in
Keyboard-controller board
Removing the keyboard-controller board
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
2230 solid-state
4. Remove the
2280 solid-state
5. Remove the battery.
About this task
The following image indicates the location of the keyboard-controller board and provides a visual representation of the removal
procedure.
Steps
1. Remove the two screws (M2x1.9) that secure the keyboard-backlight cable to the keyboard-controller board.
2. Disconnect the keyboard-backlight cable from the keyboard-controller board.
3. Open the latch and disconnect the keyboard-controller board cable from the keyboard-controller board.
30
drive. (if applicable)
drive. (if applicable)
After working inside your
Before working inside your
drive. (If applicable)
drive. (If applicable)
computer.
computer.
Advertisement
Table of Contents
