Manual Dosing - Siemens WN54A2A0HK Instruction Manual And Installation Instructions

Intelligent dosing system
en
Open the dispenser lids.
2.
Pour liquid detergent and fabric
3.
softener into the relevant dispensers.
Notes
– Do not fill the dispensers above
the max. marking.
– See the instructions in chapter
~ "« i-Dos Setting the dosage"
on page 39
Close the dispenser lids.
4.
To prevent the detergent
Note:
drying out or drying up, do not leave
the dispenser lids open for a long
period of time.
Push in the detergent drawer.
5.
40
When refilling the dispensers,
Note:
always use the same type of liquid
detergent or fabric softener.
Do not mix different types of liquid
detergent or fabric softener, as this can
form lumps that may block the « i-Dos
pump unit.
If you switch to a different liquid
detergent or fabric softener (type,
manufacturer, etc.), empty the relevant
dispenser completely and clean it
beforehand. ~ Page 41

Manual dosing

For programmes in which automatic
dosing is not possible or desirable, or in
which it has been deactivated, you will
need to add detergent to the manual
dosing compartment.
The detergent and/or care product in
this compartment is dispensed when
the wash cycle starts. Do not add fabric
softener or any other products that
should not be used until later in the
wash cycle (e.g. during rinsing).
Note: Programmes with prewash
When automatic dosing is deactivated,
place the detergent for the prewash in
the drum. Pour washing powder for the
main wash into the manual dosing
compartment.
Dosing and adding detergent
Find out the optimum dosage for
Note:
detergent and care product.
Pull out the detergent drawer.
1.
* Depending on the model
*
: