Table of Contents
Advertisement
Assembly Instructions
Keys treadmills are shipped in two pieces: the console assembly and the base. The following
steps should be followed for assembling the treadrrtill:
Remove any packing materials from the treadmill. Do not throw away any packing materials
until assembly is completed.
Place the base on a clean, level surface. Make sure the electrical cord will easily reach an
electrical outlet.
1. Raise the console into an upright position and install 3.5" x 5/16" bolts (2} with washers and
secure using S/16" nyloc ruts (2) (Diagram 1).
2. Find the wire harness exiting from the left upright Plug wire harness into motor controller
circuit board. Tie off excess wire with the attached plastic tie (Diagram 1).
3. Install motor hood cover using 5/8" phillips head screws (8 screws) (Diagram 1).
4. Handlebar installation. Handlebars include toggle switches for speed and incline. Incline
toggle switch is on the left (as you stand on the treadmill). Plug in wire harnesses for each
side and push excess wire Into holes (Diagram 2).
5. Attach left and right handlebars with 5" all thread bolts Loosely tighten (Diagram 3).
6
Loosely attach bottom side of handrails to uprights with 1" button head screws (Diagram 3).
7, Install cross handlebar with 2 Va button screws (Diagram 3).
8- Securely tighten all handrail bolts and screws.
9
Be sure that the treadmill is level to the floor. The rear feet can be adjusted to level the
treadmill. Assembly is complete!
7
Advertisement
Table of Contents
