Table of Contents
Advertisement
PRISM
CENTRAL SYSTEM 2
®
INSTALLATION OF PRISM
(AD1326-25 & AD1326-26)
TOOLS NEEDED
• 5/16" Nutdriver
• 9/16" Nutdriver
• Ladder/Lift
• Drill + 1/4" Drill Bit
Step 1 - Unpack The Unit
Place pallet near intended installation location and unpack in
preparation for assembly.
FIGURE A.1
Door key located
in parts bag
inside dust bin
DUST BIN BOX
(contains Operators Manual
and installation parts)
Step 2 - Lift The Unit For Final Assembly
1.
To lift unit for final assembly using fork truck,
place forks through front and rear fork pockets.
NOTICE: Ensure forks are perpendicular to fork
pockets to prevent damage to hopper.
(See Fork Pocket Locations in Figure A.2)
2.
After lifting unit, remove shipping brackets
from bottom of legs. Save to reinstall on
bottom of leg extensions in Step 3.
(See Shipping Braket locations in Figure A.2)
®
CENTRAL SYSTEM 2
SILENCER
LEG EXTENSIONS
FIGURE A.2
SHIPPING BRACKET
Step 3 - Assemble Leg Extensions
1.
Install Leg Extensions as shown using supplied 3/8-16
bolts and nuts (8 each per leg) (See Figure A.3).
2. To ensure unit stability during remaining installation
steps, install shipping braces as shown (See Figure A.3).
3.
Place unit on floor in desired location. Keep Shipping
Braces installed until unit's legs are bolted to the
floor during a later step (See Figure A.3).
INSTALLATION
HOPPER
SHIPPING BRACKET
FORK POCKETS
Advertisement
Table of Contents
