Toggling The Qt/Dqt Decode Between Enabled And Disabled (Decode Signaling Enable/Disable); Toggling The Qt/Dqt Encode Between Enabled And Disabled (Encode Signaling Enable/Disable) - Kenwood TKR-D710 Function Reference

6 ANALOG COMMUNICATIONS
6.1 Using Signaling

Toggling the QT/DQT Decode Between Enabled and Disabled (Decode Signaling Enable/Disable)

Decode Signaling Enable/Disable is the function to enable or disable the QT/DQT decode.
If Decode Signaling Disable is enabled, the repeater cannot decode QT/DQT.
The QT/DQT decode can be toggled between enabled and disabled when a PF key is operated, when a signal is
applied to an AUX Input port, or when the repeater is turned on.
Table 6-1 Toggling the QT/DQT Decode Between Enabled and Disabled
Trigger
PF key
AUX Input Port
Startup
Note
• The QT/DQT decode cannot be toggled between enabled and disabled when transmitting using the Repeat PTT control. The
QT/DQT decode can be toggled between enabled and disabled while transmitting using anything other than the repeat
behaviors.
• When transmitting using the Repeat PTT control while Decode Signaling Disable is enabled, the QT/DQT (Primary)
configured for each channel is used for the signaling of the downlink signal from the repeater.
• If the repeater waits to receive on a mixed channel, this function works only when an analog signal is received.

Toggling the QT/DQT Encode Between Enabled and Disabled (Encode Signaling Enable/Disable)

Encode Signaling Enable/Disable is the function to enable or disable the QT/DQT encode.
If Encode Signaling Disable is enabled, the repeater cannot encode QT/DQT.
The QT/DQT encode can be toggled between enabled and disabled when a PF key is operated, when a signal is
applied to an AUX Input port, or when the repeater is turned on.
Table 6-2 Toggling the QT/DQT Encode Between Enabled and Disabled
Trigger
PF key
AUX Input Port
Startup
Note
• The QT/DQT encode cannot be toggled between enabled and disabled during transmission. (Encode Signaling Enable/
Disable)
• When transmitting using the Repeat PTT control while Decode Signaling Disable is enabled, the QT/DQT (Primary)
configured for each channel is used for the signaling of the downlink signal from the repeater.
• If the repeater transmits on a mixed channel, this function works only when an analog signal is transmitted.
FUNC (E)/Ver 2.50
Assigned Function
Decode Signaling Enable/Disable
Decode Signaling Disable
Decode Signaling Enable
Decode Signaling Enable/Disable
Decode Signaling Disable
Decode Signaling Enable
Assigned Function
Encode Signaling Enable/Disable
Encode Signaling Disable
Encode Signaling Enable
Encode Signaling Enable/Disable
Encode Signaling Disable
Encode Signaling Enable
See
Available Functions for the PF Keys
Available Functions for the AUX Input
Ports
Available Functions for Startup
See
Available Functions for the PF Keys
Available Functions for the AUX Input
Ports
Available Functions for Startup
CONTENTS INDEX 32