Yamaha PF-1000 Owner's Manual page 151

4
Raising the stand to the standing position.
Use the front legs as
support to raise the
stand.
CAUTION
Be careful not to pinch your fingers.
5
Mounting the keyboard.
Be sure to hold the four corners of the
keyboard.
Mount the keyboard so that the rubber feet
on the bottom of the keyboard fall into the
holes on the stand.
CAUTION
Be careful not to pinch your fingers or drop the
keyboard.
CAUTION
Do not hold any part of the keyboard other than four
corners as shown in the illustration.
6
Fixing the keyboard.
Attach the cap bolts on the
bottom of the stand and tighten
them with your hand to fix the
keyboard.
Assembling the Keyboard Stand
7
Connecting the pedal unit.
1 Place the pedal unit in front of the rear legs.
3
3 Attach the cord holders in the position shown in the
illustration, and clip the pedal cord to the holders.
* You can also clip the power cord to the cord holders.
8
Set the voltage selector and connect the power
cord to the AC INLET on the keyboard.
VOLTAGE SELECTOR
Voltage Selector
Before connecting the AC power cord, check the setting of the
voltage selector (provided in some locations). To set the selector for
110V, 130V, 220V or 240V main voltages, use a "minus" screwdriver
to rotate the selector dial so that the correct voltage for your region
appears next to the pointer on the panel. The voltage selector is set
at 240V when the unit is initially shipped.
After the proper voltage has been selected, connect the AC power
cord to the AC INLET and an AC wall outlet. A plug adaptor may also
be provided in some areas to match the pin configuration of the AC
wall outlets in your area.
WARNING
An improper voltage setting can cause serious damage to the PF-
1000 or result in improper operation.
After completing the assembly, please check the
following.
• Are any parts left over?
• Review the assembly procedure and correct any
errors.
• Is the PF-1000 clear of doors and other movable fix-
tures?
• Move the PF-1000 to an appropriate location.
• Does the PF-1000 make a rattling noise when you
shake it?
• Tighten all screws.
• Are the pedal and power cords inserted securely into
the sockets?
• Check the connections.
• If the keyboard stand creaks or is otherwise unsteady
when you play the keyboard, refer to the assembly
diagrams and retighten all screws.
2
PE DA L
2 Connect the pedal cord plug
into the PEDAL jack on the left
side of the keyboard, with the
arrow on the plug facing up.
AC INL ET
PF-1000
151