Using The Midi Terminals - Yamaha PF-1000 Owner's Manual

Using Your PF-1000 with Other Devices
Using the TO HOST terminal
Connect the serial port of the personal computer (RS-
232C terminal or RS-422 terminal) to the TO HOST
terminal of the PF-1000. For the connection cable, use the
appropriate cable below (sold separately) that matches
the personal computer type.
If your system does not work properly with the connections and set-
tings listed above, your software may require different settings.
Check your software operation manual and set the HOST SELECT
switch to the proper data transfer rate. (Data transfer rate of "PC-1"
is 31,250 bps.)
I IBM-PC/AT (Windows)
Connect the RS-232C terminal on the computer to the
TO HOST terminal on the PF-1000 using a serial cable
¡
(D-SUB 9P MINI DIN 8P cross cable). Set the PF-
1000 HOST SELECT switch to the "PC-2." (Data
transfer rate is 38,400 bps.)
PF-1000
HOST SELECT
MIDI PC-2 PC-1 Mac
I Macintosh
Connect RS-422 terminal (modem or printer) on the
computer to the TO HOST terminal on the PF-1000
using a serial cable (system peripheral cable, 8 bit). Set
the PF-1000 HOST SELECT switch to the "MAC" (Data
transfer rate is 31,250 bps).
Set the MIDI interface clock in the sequencer you are
using to 1 MHz. For details, refer to the owner's
manual for the particular software you are using.
PF-1000
HOST SELECT
MIDI PC-2 PC-1 Mac
144
PF-1000
NEC MultiSync
PC-9821 A S
MINI DIN D-sub
8-pin 9-pin
MINI DIN D-sub D-sub
8-pin 25-pin 9-pin
* When using a D-SUB 25P
¡ MINI DIN 8P cross
cable, connect using a D-
SUB9P plug adaptor on
the computer side of the
cable.
MINI DIN MINI DIN
8-pin 8-pin

Using the MIDI terminals

When using a MIDI interface device installed in the
personal computer, connect the MIDI terminals of the
personal computer and the PF-1000 with standard MIDI
cables.
• When the computer has a MIDI interface installed,
connect the MIDI OUT terminal of the personal
computer to the MIDI IN terminal. Set the HOST
SELECT switch to "MIDI."
PF-1000
HOST SELECT
MIDI PC-2 PC-1 Mac
• When using a MIDI interface with a Macintosh series
computer, connect the RS-422 terminal of the
computer (modem or printer terminal) to the MIDI
interface, then connect the MIDI OUT terminal on the
NEC
MIDI interface to the MIDI IN terminal of the PF-1000,
as shown in the diagram below.
Set the HOST SELECT switch to "MIDI."
PF-1000
HOST SELECT
MIDI PC-2 PC-1 Mac
• When the HOST SELECT switch is set to "MIDI," the
TO HOST terminal is disabled.
• When using a Macintosh series computer, set the
MIDI interface clock setting in the application
software to match the setting of the MIDI interface
you are using. For details, refer to the owner's
manual for the particular software you are using.
MIDI IN MIDI OUT
NEC MultiSync
MIDI OUT MIDI IN
A
PC-9821 S
MIDI IN
RS422
MIDI OUT
MINI DIN
8-pin
NEC