Advertisement
5.
5
Attach the LatchHousing (73)tothebft Upright
(84)withtwoScrews (3);start bothScrews
andthentightenbothScrews.Makesurethat
the targeholein the LatchHousingis on the
indicatedside.
Remove t heknobfromthepin.Makesurethat
thecollar andthespring areonthepin.(Note: i f
therearetwocollars, p lace oneoneachsideof
thespring.) i nsertthepinintothe LatchHousing
(73).Then, t ighten theknobontothepin.
MakesurethataHpartsareproperlytightenedbeforeyou usethe treadmill if therearesheetsofclear
pUastb o nthetreadmHU
decab,remove thepUastb. Toprotect t heflooror carpet, p Uace a matunder thetread°
mill Note:Extrahardware m aybeincluded. Keep theincluded hexkeyina secure pUace; theUarge h exkeyis
usedtoadjust t hewaUMng beUt (seepage19).
if you purchase
the optional
chest puJse sensor (see
page 18}, follow the steps below to instatt the receiver
included
with the chest pulse sensor.
1. Make sure that the power cord is unplugged.
Remove
the indicated Screw (3) and the Access Door (76) from
the back side of the Consob Base (85).
2. Connect the wire on the receiver (A) to the indicated wire
extending from the Console Base (85). Hold the re-
ceiver so the small cylinder
is oriented
as shown and
is facing the Console
Back. Attach the receiver to the
plastic posts on the Access Door (76) with the two in-
cluded small screws.
3. Make sure that no wires are pinched.
Reattach the
Access Door (76) with the Screw (3). Discard the other
wires included with the receiver.
8
Advertisement
