Connecting External Components - Yamaha GX-505RDS Owner's Manual

(1)
75
(2)
SUBWOOFER
AUX/MD
R
MD recorder, etc.
ANTENNA
FM GND AM
UNBAL.
ANTENNA
FM GND AM
75 UNBAL.
DIGITAL OUT
OPTICAL
ANTENNA
FM GND AM
75 UNBAL.
DIGITAL OUT
OPTICAL
OUT
L
OUT
IN
R
Preparations and connections
Antenna connection
(1) Supplied FM antenna
Connect the FM antenna wire to the corresponding terminal and
direct it to the direction where the strongest signal can be received.
(2) Supplied AM loop antenna
Connect the AM loop antenna wires to the corresponding
terminals. Position the AM loop antenna for optimum reception.
Notes
• When static is still heard even after adjusting the position of the AM loop
antenna, try reversing the wire connections (from the right terminal to
the left one, and vice versa).
• The AM loop antenna should be placed apart from the main unit. The
antenna may be hung on a wall.
Using an external antenna
• If you need better reception, use an external FM antenna instead
of an indoor FM antenna. Consult your dealer.
• Use an external AM antenna if you need better reception.
Consult your dealer.

Connecting external components

This system can be connected with an external audio component.
Make connections between this system and the component using
RCA pin plug connector cables, by correctly connecting L (left) to
L and R (right) to R. Also, refer to the owner's manual for the
component to be connected to this system.
* A digital-to-digital recording is possible from a CD played on
the built-in CD player to an MD (or tape) on an external MD
recorder (or DAT) by connecting the DIGITAL OUT
(OPTICAL) terminal on the rear of the main unit to the MD
recorder (or DAT).
-7
E