Antenna Connection; Connecting External Components - Yamaha GX-700VCD Owner's Manual

Preparations and connections
(1)
(2)
TV monitor
VCR
LD/DVD player, etc.
MD recorder, etc.
E-8
ANTENNA
FM GND AM
75 UNBAL.
ANTENNA
FM GND AM
75 UNBAL.
DIGITAL OUT
OPTICAL
(Singapore model)
ANTENNA
FM GND AM
75 UNBAL.
DIGITAL OUT
OPTICAL
SPEAKERS
TV MODE
PAL SEE OWNER'S M
FOR CONNECTIO
AUTO
NTSC
REAR R CENTER
SUBWOOFER
VIDEO SIGNAL
OUT
MONITOR
OUT
R L
OUT
CENTER: 6 MIN./S
VCR REAR: I2 MIN./S
IN
VIDEO
OUT
AUX/MD
IN
R FRONT
(Singapore model)

Antenna connection

(1) Supplied FM antenna
Connect the FM antenna wire to the corresponding terminal
and direct the FM antenna wire to the direction where the
strongest signal can be received.
(2) Supplied AM loop antenna
Connect the AM loop antenna wires to the corresponding
terminals. Position the AM loop antenna for optimum
reception.
Notes
● When static is still heard even after adjusting the position of
the AM loop antenna, try reversing the wire connections
(from the right terminal to the left one, and vice versa).
● The AM loop antenna should be placed apart from the main
unit. The antenna may be hung on a wall.
Using an external antenna
● Use an external FM antenna instead of an indoor FM
antenna if you need better reception. Consult your dealer.
● Use an external AM antenna if you need better reception.
Consult your dealer.

Connecting external components

TV monitor
Connect a TV monitor to enjoy playing Video CDs on the built-
in CD/Video CD player. Connect a TV monitor to the
MONITOR OUT terminal using an RCA pin plug cable.
External audio and video components
This system can be connected with external audio and video
components. Make connections between this system and the
components using RCA pin plug connector cables correctly,
that is to say L (left) to L and R (right) to R. Also, refer to the
owner's manual for the component to be connected to this
system.
* A digital-to-digital recording is possible from a CD played on
L
the built-in CD/Video CD player to an MD (or tape) on an
external MD recorder (or DAT) by connecting the DIGITAL
OUT (OPTICAL) terminal on the rear of the main unit to the
MD recorder (or DAT).