Antenna Connection; Connecting External Components - Yamaha GX-505VCD Owner's Manual

(1)
75
FREQUENCY STEP
50
100
(2)
FREQUENCY STEP
100
TV monitor TV MODE
SUBWOOFER
AUX/MD
R
MD recorder, etc.
ANTENNA
FM GND AM
UNBAL.
ANTENNA
FM GND AM
75 UNBAL.
DIGITAL OUT
H 9 H OPTICAL
K Z K Z
FM AM
K H Z 10 K H Z
ANTENNA
FM GND AM
75 UNBAL.
DIGITAL OUT
50 H 9 H OPTICAL
K Z K Z
FM AM
H 10 H
K Z K Z
PAL
AUTO
NTSC
VIDEO SIGNAL
OUT
MONITOR
OUT
L
OUT
IN
R
Preparations and connections

Antenna connection

(1) Supplied FM antenna
Connect the FM antenna wire to the corresponding terminal and
direct it to the direction where the strongest signal can be received.
(2) Supplied AM loop antenna
Connect the AM loop antenna wires to the corresponding
terminals. Position the AM loop antenna for optimum reception.
Notes
• When static is still heard even after adjusting the position of the AM loop
antenna, try reversing the wire connections (from the right terminal to
the left one, and vice versa).
• The AM loop antenna should be placed apart from the main unit. The
antenna may be hung on a wall.
Using an external antenna
• If you need better reception, use an external FM antenna instead
of an indoor FM antenna. Consult your dealer.
• Use an external AM antenna if you need better reception.
Consult your dealer.

Connecting external components

TV monitor
Connect a TV monitor to enjoy Video CDs on the built-in CD/
Video CD player. Connect a TV monitor to the MONITOR OUT
terminal using an RCA pin plug cable.
External audio and video components
This system can be connected with external audio and video
components. Make connections between this system and the
components using RCA pin plug connector cables, by correctly
connecting L (left) to L and R (right) to R. Also, refer to the
owner's manual for the component to be connected to this system.
* A digital-to-digital recording is possible from a CD played on
the built-in CD/Video CD player to an MD (or tape) on an
external MD recorder (or DAT) by connecting the DIGITAL
OUT (OPTICAL) terminal on the rear of the main unit to the
MD recorder (or DAT).
-7
E