One-Touch Memory Operation - Yaesu VX-7R Operating Manual

M M
EMORY
The One-Touch feature allows you to recall up to ten favorite frequencies directly via the
numeric ( through
One-Touch Memory Storage
1. Select the desired frequency, while operating in the VFO mode. Be sure to set up any
desired CTCSS or DCS tones, as well as any desired repeater offset. The power level
may also be set at this time, if you wish to store it.
2. Press and hold in the
3. Within five seconds of releasing the
DIAL to select the desired One-Touch Memory channel,
which will be labeled "OTM0" through "OTM9."
4. Press the key once more to store the frequency into
the selected One-Touch Memory.
5. You still will be operating in the "VFO" mode, so you may now enter other frequen-
cies, and store them into additional One-Touch Memory locations, by repeating the
above process.
One-Touch Memory Recall
1. Set the VX-7R to Mono band operation on the "Main" band.
2. Press the key, then press the
3. Rotate the DIAL knob to select the "3 OTM" mode.
4. Press the PTT switch to activate the "One-Touch Memory"
mode.
5. Press the numeric key (
the One-Touch memory you wish to recall.
6. To exit the One-Touch Memory mode, recall the Special
Memory Menu (press
to "1 OFF."
54
ODE
O -T
NE OUCH
) keys.
key for 1/2 second.
through
+ ), then change its setting
M M
EMORY ODE
key, rotate the
key to recall the Special Memory Menu.
) corresponding to
VX-7R O M
PERATING ANUAL