How To Install The Quick Draw Belt Clip; Installation Of Fnb-80Li Battery Pack - Yaesu VX-7R Operating Manual

I
NSTALLATION OF
H
OW TO
1. Connect the hanger to the rear of the VX-7R, with the notch pointing directly up, using
the supplied screw (Figure 1). Use only the screw included with the clip to mount
the clip to the back of the VX-7R!
2. Clip the Quick-Draw Belt Clip onto your belt (Figure 2).
3. To install the VX-7R into the Quick-Draw Belt Clip, align the hanger with the Quick-
Draw Belt Clip, and slide the VX-7R into its slot until a click is heard (Figure 3).
4. To remove the VX-7R from the Quick-Draw Belt Clip, rotate the VX-7R 180 degrees,
then slide the VX-7R out from the Quick-Draw Belt Clip (Figure 4).
Figure 1
I
NSTALLATION OF
The FNB-80LI is a high-performance Lithium-Ion battery providing high capacity in a
very compact package. Under normal use, the FNB-80LI may be used for approximately
300 charge cycles, after which operating time may be expected to decrease. If you have an
old battery pack which is displaying capacity which has become diminished, you should
replace the pack with a new one.
1. Install the FNB-80LI as shown in the illustration.
2. Close the Battery Pack Latch on the bottom of the radio.
8
A
CCESSORIES
I Q
NSTALL THE
Figure 3
Figure 2
FNB-80LI B
D B
UICK RAW ELT
Figure 4
ATTERY
VX-7R O
C
LIP
P
ACK
M
PERATING ANUAL