Code Transmission - Kenwood TM-732A Instruction Manual

For example, the following groups communicate with
each other.
Predetermined frequency 145.660MHz
Your Individual code 111
Member 1 Individual code 222
Member 2 Individual code 333
Member 3 Individual code 444
Group code 789
Member 1
Your memory PA 222
PA 111 P2 789
PO
Pl 222 Member 2
P2 333
PA
333
P3 444 P3 789
P4
P5 789 Member 3
PA 444
P4 789
3-6. Code Transmission
Your station ID code should be programmed in Paging
Code Memory Channel PA.
1. Select the desired operating frequency.
2. Press the SHIFT/DTSS key until the Paging mode
indicator appears. (The Paging mode should be
active on the other transceiver also!)
3. Press the F key for longer than 1 second and press
the SHIFT/DTSS key. The Paging Mode Memory
Channel Indicator will begin flashing.
4. Select the desired Paging Code Memory Channel
with the tuning control or microphone UP/DWN key.
5. Press any key except the SHIFT/DTSS key to return
to the frequency display.
6. Press the PTT switch. The selected transmit code
will be transmitted along with your station ID code
(the one stored in PA).
Notes
If the remote transceiver is in the battery save mode, the code may
not be received. To be sure the code is received, transmit it for
several seconds, release the PTT key, and transmit again.
69