Kenwood TM-732A Instruction Manual page 13

2. Fixed Station
Caution :
1. Never connect the AC power cable to the AC
outlet until all other connections have been made.
2. Before connecting and disconnecting the power
connector, be sure to turn OFF the POWER
switches of both the transceiver and the DC
power supply.
3. Observe polarity of the DC power cable. The
Fuse 15 A
cere transceiver operates on 13.8 VDC, negative
Make sure the positive (+) and negative (—) lead polarity is ground. Battery polarity must be correct. The
correct when connecting to the battery. power Cable is color coded :
pai Engine compartment+—}{ —- Passenger compartment Red — + (Positive polarity)
ec Fuse
D
Black — — (Negative polarity)
oN —-—
" S | Make sure the cable ]
| does not directly contact
| the edge of the hole by |
using a grommet.
mois-
when (Chassis or
fire wall, §$\~———_——____
@ If the wiring hole in the fire wall or chassis is too small,
disassemble the fuse holder to thread the wire through the
hole.
From passenger
compartment
Thread like;this Leave enough space around the fan on the rear
panel for good ventilation.