Kenwood TM-732A Instruction Manual page 25

Hi RECEIVER OPERATION
Before switching the power on, set the controls as
(Fixed station): Regulated DC stabilized power supply
| power switch: Off
Both Vol Control Both SQL Control
Full Counterclockwise Full Counterclockwise
The following example will prepare the transceiver to
receive a frequency of 145.020 MHz.
1. First turn on the regulated DC power supply, then
press the POWER key on the front of the
transceiver.
A frequency will be displayed after a delay of approximately 1
second. The factory default for the 2 meter band is 144.000 and
the default for 70 cm is 440.000 (or 430.000 for some
destinations.)
2. Press the upper BAND SEL key to select the 2
Meter band.
Pressing the upper BAND SEL key
permits control of the 2 Meter band with
the various front panel controls etc.
The LED
lights.
i Pressing the lower BAND SEL key
} permits control of the 70 cm band with !
: the various front panel controls etc. '
3. Turning the upper VOL control in a clockwise
direction will permit a signal, or noise to be heard
from the speaker. Adjust the VOL control toa
comfortable level.
4. Rotate the tuning control and select an open
frequency (no signal is present.)
When the tuning control is rotated in a clockwise
direction the frequency increases, rotating the control
counterclockwise decreases the frequency.
25