Kenwood TM-732A Instruction Manual page 20

2. Display Panel
@ A.LOCK
@® APO
©
© MUTE
@ TOT
® A.B.C.
@ Ve
oF
20
ae a
seg age sae
Indicates the TX band.
On when two UHF band signals are
received at the same time.
On when the Lock function has
been activated.
On when the All Lock function has
been activated.
On when the Automatic Power Off
function has been activated.
On whenever the F key has been
depressed.
On when the volume of the RX band
is reduced.
On when the Time-Out Timer
function has been activated.
On when the Automatic Band
Change function has been activated.
On when two VHF band signals are
received at the same time.
Displays the selected transmitter
offset direction.
® ©
LM
a
cxsyeeeett lll]
g
On when the Reverse function has
been activated.
Shows the last memory channel
number that was selected. The *
indicator is on when the Memory
channel will be skipped during
Memory channel scan.
On when the DTSS function is
active.
With the optional CTCSS unit TSU-
7: On when the Tone Decode
function is active.
On when the Tone Encode function
is active.
On when Carrier Operated scan is
selected.
Indicates the relative output power
setting for transmit. No indicator
indicates full power.
On during transmit.
This level meter indicates the
relative receiver signal strength or
the relative transmitter power
output.
On when the squelch opens.
On when the Tone Alert function is
active.
99844 &z Displays the operating frequency to
the nearest kHz digit, or the tone
frequency.
The indicator flashes when
scanning.