Message Transmission And Reception; Message Transmission Modes; Using The Message Memory - Kenwood TH-28A Instruction Manual

MESSAGE TRANSMISSION AND RECEPTION
This function lets you transmit your message to the 2 Using the Message Memory.
other party or display a message from the other party
on your transceiver using the DTMF (Dual Tone Multi This transceiver has 10 message memory channels.
Frequency) signal and alphanumeric display. Memory write procedure
You can use the numerics 0 to 9, letters A to Z and 1 Press the M key, then press the MESSAGE key to
space. enter the message setting mode.
The message that can be transmitted and received
at one time can be up to six characters long.
Note
This function is used with DTSS or paging.
1 Message Transmission Modes
You can transmit your message by one of the
following twe methods. 2. Enter your message with the DTMF keypad. See the
i Transmit your message directly using the DTMF list on the next page for the key combinations for
keypad. You must press the # key at the beginning each letter.
ang.end onthe character 3 If you enter the wrong message, press the VFO key
See the list on the next page for combinations of to start over step 1.
keys for alphabets: 4 Press the MR key at the end. The MSG display
@ Store your message in the message memory, and begins flashing.
transmit it.
42