Cannot Connect To The Fiery Exp4110 With Utilities; Cannot Connect To The Fiery Exp4110 With Command Workstation - Xerox 4110 Configuration And Setup

T
ROUBLESHOOTING

Cannot connect to the Fiery EXP4110 with utilities

If users cannot connect to the Fiery EXP4110, check the following:
The appropriate network protocol must be enabled, with the correct
Fiery EXP4110 Setup:
parameters (for example, for TCP/IP, the IP address). You must publish either the Print queue
or Hold queue.
You can check these settings quickly by printing a Configuration page.
The appropriate network protocols must be loaded.
On the client computer:

Cannot connect to the Fiery EXP4110 with Command WorkStation

If there is a problem connecting to the Fiery EXP4110, an error message is displayed.
The problem can occur when:
• The Fiery EXP4110 is initially turned on
• The Fiery EXP4110 restarts
• You have changed settings affecting the server address and have not reconfigured the
connection to the server
If you experience this problem, try the following solutions, in this order:
• A remote workstation running utilities or WebTools may be interfering by obtaining status
information. If possible, close the remote application, and try to connect again.
• Restart the Command WorkStation software and try to connect again.
• Restart the Fiery EXP4110.
99