Server Setup Options - Xerox 4110 Configuration And Setup

S
ETTING UP THE

Server Setup options

The Server Setup menu lets you specify system information that pertains to the
Fiery EXP4110 and all users. To access the menu, follow the instructions on
Exit Setup
Server Setup
Network Setup
Printer Setup
Setup
When you choose Server Setup, the options appear in sequence, as follows. Default values,
where applicable, appear in square brackets. Words shown in italics indicate that a product- or
site-specific value is displayed.
Server Name
Default server name
Enter a name for the Fiery EXP4110 (up to 15 characters long). This name appears in the
Chooser on an AppleTalk network.
Do not use the device name (4110) as the server name. Also, if you have more than one
N :
OTE
Fiery EXP4110, do not give them the same name.
System Date
Enter the correct system date in the standard form for your use. The date appears on the Job
Log.
System Time
Enter the correct system time. Enter the time based on the 24-hour clock in the form
(Hours:Minutes). The time appears on the Job Log.
Time Zone
Set the date and time the Fiery EXP4110 displays as the default. Select the appropriate time
zone from a list of supported zones.
Daylight Saving
This option appears when you specify a time zone in which some areas observe Daylight
Savings Time and other areas do not.
Print Start Page
Yes/No [No]
Specify whether the Fiery EXP4110 should print a start page every time it restarts. The start
page displays information about the Fiery EXP4110, including the server name, current date
and time, amount of memory installed in the Fiery EXP4110, network protocols enabled,
and connections published.
F EXP4110
IERY FROM THE
Press button for Server Setup
C P
ONTROL ANEL
30
page 28.
HH:MM