Configuration Steps - Mvs - Xerox 4050 Installation Planning Manual

DEFINING THE PRINTER TO THE HOST: TCP/IP ATTACHMENT
Configuration steps – MVS
1. Configure the IPS printer for TCP/IP at the GUI
2. Configure the MVS CCU for the MVS host to MVS
3. Configure the PSF printer in JES2 or JES3
Configuring in JES2
E-2
•
Configurations in which the LAN with the printer attached is
connected to the host-attached controller using LAN devices
such as routers
•
Environments with intermediate host systems between the
MVS host running PSF and the LAN-attached controller.
Note: There may be printer performance and throughput
implications with some of these configurations. It is recommended
that your network management group be involved with planning this
installation.
The software configuration process for IPS in an MVS or OS/390
environment with TCP/IP consists of five major steps:
Refer to your IPS Guide to Configuring and Managing the System,
chapter 4, "Setting the system configuration," for this graphical user
interface (GUI) procedure.
The MVS communications control unit (CCU) could be the 3172,
3174, or 3745 control unit. To configure it to MVS, you can use either
a hardware configuration definition (HCD) or an MVS configuration
program (MVSCP). If your control unit and LAN are already installed
and operational, skip this step.
Note: The AFP1 parameter used when channel0attached IPDS
printers are defined is not applicable in this configuration. It is the
communications control unit (3172, 3174, or 3745) that is being
defined to MVS, not the printer's control unit.
This section discusses the procedures for configuring the IPS in
JES2 or JES3 environments.
To configure the PSF printer in JES2, follow these steps:
1. Locate the JES2 initialization dataset in the JES2 Startup JCL
Procedure (JES2 PROC). (This is normally kept in
SYS1.PROCLIB, although your system may use a different
library.)
The JES2 PROC has a DD statement (normally HASPPARM),
which points to the initialization dataset. (The location of this
statement is 'SYS1.PARMLIB(JES2PARM);' however, you
should always verify the location on your own system.)
XEROX DOCUPRINT 4050/4090 IPS INSTALLATION PLANNING GUIDE