Xerox 4050 Installation Planning Manual page 113

Item
description Default
FSSNAME None
MSGDEST JES
PNAME None
SYSTEM Same as
specified in
JUNIT
parameter of
DEVICE
statement
TERM NO
TYPE
BURST YES
COPYMARK J
DGROUP None
DTYPE None
DYNAMIC NO
XEROX DOCUPRINT 4050/4090 IPS INSTALLATION PLANNING GUIDE
Table E-3.
Range of
Source of value acceptable values Comments
Installation 1 to 8-character
preferences alphanumeric string
Installation JES or a destination
preferences class name
Name of the FSS 1 to 8-character
procedure alphanumeric string
System ID of system Valid system ID
the FSS is to run on. name
Installation YES or NO
preferences
TYPE=WTR must be WTR
specified
Installation YES or NO
preferences
,M
Installation N or J or C
preferences
Installation printer 1 to 8-character
destination naming alphanumeric string
conventions
PRTAFP1 PRTAFP1
Installation printer YES or NO
name standards
DEFINING THE PRINTER TO THE HOST: TCP/IP ATTACHMENT
JES3 FSS statement parameters
Specifies name of the FSS.
(Required parameter)
Specifies the console
destination class for FSS
messages.
Specifies the procedure for
starting this FSS. (Different
FSSDEF statements may
refer to same procedure.)
Can also be specified as
QUEUE=
YES specifies FSS
terminates if JES3 global
address space is
terminated.
Specifies FSS is an output
writer. TYPE=WTR must
be specified.
,M specifies MARKFORM,
which causes IPS printer to
offset-stack or stitch jobs,
subject to printer's setting
and the COPYMARK
parameter.
C: IPS will offset-stack or
stitch on a dataset copy
basis.
J: Printer is to increment
offset stacking or stitching
on a job boundary.
N: Copymarks are
constant, and no offset
stacking or stitching is
done.
Specifies destination
processed by this FSA
(applicable only if D is
specified in the WS
parameter).
Required parameter
DYNAMIC=NO should be
specified so JES3 will keep
FSA active between
transmission of datasets.
Your value
E-5