Xerox 4050 Installation Planning Manual page 46

CONTROLLER SPECIFICATIONS AND REQUIREMENTS
5-6
The following illustration shows fan and vent locations on the
front and back of the controller.
Figure 5-4. Sun Ultra 60 fan and vent locations to keep clear
1 Vent in front of processor
2 Fan in back of processor
3 Vent in back of processor
Do not:
•
Do not place the controller monitor on top of the processor.
•
Do not allow any piece of equipment to blow warm air into the
air intake vents of the processor.
•
Do not place the processor on its side, or in any other position
but the upright, vertical position shown in the previous figure.
•
Do not place the processor or monitor on top of the printer.
XEROX DOCUPRINT 4050/4090 IPS INSTALLATION PLANNING GUIDE