Xerox 4050 Installation Planning Manual page 44

CONTROLLER SPECIFICATIONS AND REQUIREMENTS
Sun Ultra 2 workstation placement
5-4
Caution: Position the table(s) at least 6 inches / 15.2 cm from the
wall. Make sure the workstation processor and the HCU are at least
12 inches / 30.4 cm from the wall. Do not put the processor or the
HCU on the IPS printer.
Following are guidelines for placement of the Sun Ultra 2 workstation
components of the printer controller.
Figure 5-2. Sun Ultra 2 printer controller hardware
1 Mouse and mouse pad
2 Keyboard
3 Monitor
4 Processor
5 Table
When you place your workstation processor on a table top, make
sure to allow at least 6 inches / 152 mm of unobstructed space at the
rear and both sides of the processor. Do not allow any piece of
equipment to blow warm air into the air-intake vents of the processor.
Caution: Do not place a monitor with a base larger than the
processor on top of the unit. Do not block any fan or vents on the
sides or rear of the processor.
XEROX DOCUPRINT 4050/4090 IPS INSTALLATION PLANNING GUIDE