Table of Contents
Advertisement
INSTALL USING LATCH
Make sure the LATCH strap lays flat over the belt guides on both sides of
6
the Base Frame.
7
Push the LeverLock Door closed, making sure the door clicks into place.
8
Locate Tether Anchor in your vehicle (see pg. 48), and attach Tether
Hook. Pull Tether Adjuster Strap to tighten. Always use the Tether Strap
for installation.
CHECK YOUR WORK
Hold Base at each side near vehicle belt paths. Pull side to side and forward.
Base should not move more than 1" (25 mm) from vehicle seat back or side-to-
side.
Make sure Child Restraint is level for REAR-FACING or FORWARD-FACING use.
Install for infants, make sure infant's head does not fall forward. If necessary,
open LeverLock Door, loosen LATCH strap, re-adjust recline and repeat
installation steps to make sure Child Restraint is installed properly.
Check installation before every use!
70
INSTALL USING LATCH
7
"CLICK"
8
71
Advertisement
Table of Contents
