Table of Contents
Advertisement
INSTALLATION ON AN AIRCRAFT
3
Place lap belt over top of the Lever Lock Door and over the belt
guides.
Buckle the belt and remove all slack making sure the belt lays flat
4
over the belt guides on both sides. Then rotate the Fit360 Seat into
the Rear-Facing or Forward-Facing position. Make sure the Ready to
Ride Indicator is GREEN and not RED. If the Ready to Ride Indicator
is RED, rotate the Seat without depressing the Release Handles to
lock it into position.
CHECK YOUR WORK
Hold Base at each side near belt paths. Pull side to side and forward. Aircraft belt
should remain tight and Base should not move more than 1" (25 mm) from aircraft
seat back or side-to-side.
Make sure Child Restraint is level for REAR-FACING or FORWARD-FACING use.
Install for Infants, make sure infant's head does not fall forward. If necessary,
undo the aircraft belt, re-adjust recline and repeat installation steps to make sure
Child Restraint is installed properly.
Check installation before every use!
106
INSTALLATION ON AN AIRCRAFT
3
4
"CLICK"
107
Advertisement
Table of Contents
