TDA1200・TDA1600
Maintenance
6.
Slide on universal joint
Pull out the shaft and apply grease inside
and outside of the shaft.
Greasing points_008
Adjustment and Replacement
Precautions for Adjustment and
Replacement
Warning
Make sure that no one is near the tractor or
between it and the attachment.
Warning
Before adjusting the attachment or replacing
parts, be sure to apply the parking brake of
the tractor, set the PTO speed change lever to
the "Neutral" position, then stop the engine.
Warning
For adjusting the attachment or replacing
parts with the attachment installed on the
tractor, be sure to apply the parking brake of
the tractor, set the PTO speed change lever to
the "Neutral" position and stop the engine.
Page 6-4
Change of Tines
Caution
Wear gloves when touching tines to avoid
cutting your hands.
Important
Replace all tines at the same time.
Mixing new and old tines may cause abnormal
vibration.
1.
Stop the tractor's engine.
2.
Loosen the bolts.
3.
Remove the old tine.
4.
Fully insert the new tine into the hole in the
tine mount.
5.
While holding the tine with your hand, firmly
tighten the bolts.
6.
Check that the tine does not fall out.
8bq62b-219
Note:
Use the optional tine mount to aerate with a
finer pitch.
Important
Select and use appropriate tine mounts and
lawn pressing plates according to the tines to
be used.
Follow the steps below to install the tine mount
and tines.
1.
Secure the tine mount to the tine mount
holder with the hex socket head bolts A.
2.
Fully insert the tine into the hole in the tine
mount.
2
3
1
Change of Tines_001
1
Tine
2
Bolt
3
Tine mount
Adjustment and Replacement
ADB2CC8D