Table of Contents
Advertisement
Handling Instructions
5. Tractor
5-1. Tractor Standards
This machine employs "standard three-point link" mounting system. In the "standard three-
point link", attach the top and lower links of the tractor and the universal joint of this machine
by hand.
5-2. Preparation on The Tractor
Read the "three-point link standards" in the tractor's owner's manual carefully.
Only the tractors equipped with standard three-point link parts can be connected to this
machine.
1.If the tractor is equipped with specific three-
point link, remove the top link bracket for
specific three-point link and replace it with
standard three-point link parts.
Use the length-adjustable top link, the both
ends of which have a screw.
Attach the lift rod to the front hole of the
lower link.
2.If the moving distance when raising and
lowering the attached machine is insufficient, adjust it by changing the mounting holes on
the lift rod
● Use the upper hole to increase the moving distance when raising.
● Use the lower hole to increase the moving distance when lowering.
Top link
Top link
bracket
Leveling
handle
Lift rod
Right
lower link
Left lower link
Turn buckle
6. Adjustment before Attachment
6-1. Precautions about Attachment
Make sure there is no one around the tractor and between this machine and the tractor.
Do not get under the machine. Do not put your foot under the machine.
Before attaching the machine, apply the parking brake of the tractor, set the PTO speed
change lever to the "Neutral" position and stop the engine.
When attaching the machine, install the tractor's genuine balance weights to adjust
balance. Otherwise, the machine may lose balance and overturn.
Attach and detach the machine on a flat, stable place.
Two or more workers should attach and detach this machine since it is very heavy.
6-2. Method of Attaching The Machine
1.Place the machine on a flat, stable location.
2.Move the tractor backward to the machine and align the center position of the machine's
linkage section.
3.Raise and lower the lower links with the tractor's lift lever to align them with the link pin
position.
4.Apply the tractor's parking brake and stop the engine.
5.Chock the tractor.
6.Attach the left lower link and lock the link pin.
7.Raise and lower the lower link with the leveling handle on the right lift link to align it with
the pin position.
− 14 −
Advertisement
Table of Contents
