Caution
Rotating the PTO shaft will rotate the knife
shaft Assy.
10.
Rotate the PTO shaft while the attachment is
lowered (rear tire contacting the ground),
and check that the universal joint and
attachment make no abnormal sound.
Method of Cutting Universal Joint
Caution
Work with great caution when using a high
speed cutter.
Important
The universal joint length depends on the type
of tractor to be linked.
1.
Hold the half shafts of universal joint next to
each other in the shortest working position
between the tractor and attachment, and
mark them.
2.
Cut the inner and outer guard tubes at the
marked positions.
Method of Cutting Universal Joint_001
1
Guard tube
Installation
1
hs5tir-004
Handling Instructions
3.
Mark the shaft at the same length from its tip
as the removed guard tube.
Method of Cutting Universal Joint_002
1
Guard tube
2
Shaft
4.
Cut the inner and outer shafts at the marked
position.
Method of Cutting Universal Joint_003
1
Shaft
5.
Round off all sharp edges, remove burrs and
clean the shafts.
TDA1200・TDA1600
1
2
hs5tir-005
1
hs5tir-006
Page 5-5