TDA1200・TDA1600
Handling Instructions
Preparation for Installation
Tractor Standards
This attachment employs "standard three-point
link" mounting system.
In the "standard three-point link", attach the top
link of the tractor and the universal joint of this
machine by hand.
Preparation on The Tractor
Caution
Read the "Three-point link standards" in the
tractor's owner's manual carefully.
Important
Only the tractors equipped with standard
three-point link parts can be connected to this
machine.
If the tractor is equipped with specific three-
point link, remove the top link bracket for
specific three-point link and replace it with
standard three-point link parts.
Important
Use the length-adjustable top link with a screw
on the both ends.
1.
Attach the lift rod to the front hole of the
lower link.
1
7
6
Preparation on The Tractor_001
1
2
3
4
5
6
7
Page 5-2
2
3
4
5
57nee4-001
Top link
Top link bracket
Leveling handle
Turn buckle
Right lower link
Left lower link
Lift rod
2.
If the moving distance when raising and
lowering the attachment is insufficient, adjust
it by changing the mounting holes on the lift
rod.
Use the upper hole to increase the moving
・
distance when raising.
Use the lower hole to increase the moving
・
distance when lowering.
Installation
Precautions about Installation
Warning
Make sure there is no one around the tractor
and between the attachment and the tractor.
Warning
Do not get under the attachment. Do not put
your foot under the attachment.
Warning
Before installing the attachment, apply the
parking brake of the tractor, set the PTO
speed change lever to the "Neutral" position
and stop the engine.
Warning
When installing the attachment, install the
tractor's genuine balance weights to adjust
balance.
Otherwise, the machine may lose balance and
overturn.
Caution
Attach and detach the attachment on a flat,
stable place.
Caution
Two or more workers should attach and
detach the attachment since it is very heavy.
Installation of Attachment
1.
Place the attachment on a flat and stable
area.
2.
Drive the tractor in reverse toward the
attachment, in alignment with the center of
the attachment mount.
Preparation for Installation