Table of Contents
Advertisement
TDA1200・TDA1600
Handling Instructions
Aeration Procedure
Important
The standard working speed of tractor is 5 - 8
km/h.
Operate at low speed in the case of deep tine
depth.
1.
Raise the attachment and travel to a location
near the work site.
2.
Select the crank rotation speed using the
change lever.
3.
Combine the tractor's main transmission and
sub-transmission positions to select the
required operating speed.
4.
Set the tractor's engine rotation at low speed
less than 1500 rpm.
5.
Slowly lower the attachment while traveling.
Important
The speed of the engine rotation while
operating the tractor is as stated below.
TDA1200: 1,600 – 2,000 rpm
･
TDA1600: 1,800 – 2,300 rpm
･
The speed of the PTO rotation should be as
stated below.
TDA1200: 400 rpm
･
TDA1600: 1,000 rpm
･
Use with the PTO rotation speed exceeding
as stated above will cause damage to the
machine.
6.
Increase the engine speed until it reaches
the set value of the PTO rotation speed.
7.
Gradually increase the tractor's engine
rotation to travel forward for operation.
Note:
Keep the front roller in contact with the
ground at all times during operation. If the
machine becomes unstable, change the
PTO rotation speed to stabilize the machine.
If it does not stabilize, change the coring
depth, change the size of tines, or change
the tines with new ones.
Important
Do not stop the tractor's engine during
operation.
Otherwise, the transmission will malfunction.
Page 5-12
8.
After completing the operation, stop the
tractor, and then raise the attachment.
9.
Raise all the tines off the ground, and then
immediately stop the rotation of the PTO.
10.
Move to the next operation site, and then
perform the above procedure.
Transporting
Transporting Method
Transporting the attachment installed to a
tractor:
When loading the machine into a trailer or a
truck to transport it, drive the tractor in
reverse. When unloading, drive the tractor
forward.
Transporting only the attachment:
When loading the attachment into a trailer or
a truck to transport it, put the attachment on
a pallet and then load and unload the pallet.
Before transportation, fix the attachment on
board.
Transporting
Advertisement
Chapters
Table of Contents
