Change Of Gear Oil - Baroness TDA1200 Owner's Operating Manual

3. While holding the tine in place with your
hand, firmly tighten the hex socket head
bolts B.
4. Check that the tine does not fall out.
4
1
Change of Tines_002
1 Tine
2 Bolt w/hexagon hole A
3 Tine mount
4 Specialized lawn pressing plate
5 Bolt w/hexagon hole B

Change of Gear Oil

Caution
Be careful with hot oil, which could cause
burns if it contacts your skin.
Important
When you change the gear oil, be sure to
drain it into a container and discard it in
accordance with local laws and regulations.
Important
If the gear oil emulsifies or if it becomes even
slightly less transparent, change the oil
immediately.
Important
Use BONNOC TS680 (or equivalent) as gear
oil.
1. Follow the steps below to remove the old oil.
[1] Remove the drain plug, and then drain the
old oil into a container.
Adjustment and Replacement
3
2
5
4gr1or-002
[2] Install the drain plug.
Change of Gear Oil_001
1 Drain plug
2. Follow the steps below to supply new oil.
[1] Open the oil filler cap, supply gear oil
through the oil filling port until the oil level
reaches the middle of the oil gauge.
The gear box capacity is approximately
3
3.8 dm (3.8 L).
[2] Tighten the oil filler cap securely.
2
Change of Gear Oil_002
1 Oil filler cap
2 Oil gauge
3. On a level surface, check the oil level is at
the middle of the oil gauge. If necessary,
supply oil.
4. Check underneath the machine for oil
leakage.
TDA1200・TDA1600
Maintenance
1
FD120FF5
1
70E91CCA
Page 6-5