Gear Oil; Universal Joint; Liquid Leakage - Baroness TDA1200 Owner's Operating Manual

Gear Oil

Inspection of Gear Oil
1. On a level surface, check that the oil level
reaches the middle of the oil gauge.
2. Check underneath the machine for oil
leakage.
2
Inspection of Gear Oil_001
1 Oil filler cap
2 Oil gauge
Supply of Gear Oil
Important
Do not mix the different types of gear oil.
Important
Use BONNOC TS680 (or equivalent) as gear
oil.
1. When the gear oil level is low, follow the
steps below to supply oil.
[1] Open the oil filler cap.
[2] Supply gear oil through the oil filling port
until the oil level reaches the middle of
the oil gauge.
[3] Tighten the oil filler cap securely.
2
Supply of Gear Oil_001
Inspection and Cleaning
2.
3.
1

Universal Joint

Inspection of Universal Joint
1.
2.
70E91CCA

Liquid Leakage

Inspection of Liquid Leakage
Important
After approximately 50 hours of operation,
some tightened portions may be loosened and
liquid such as oil may leak.
Be sure to retighten the parts.
1
Important
If liquid leakage found, repair it before
operation.
Ignoring leakage will cause further trouble.
1.
2.
70E91CCA
TDA1200・TDA1600
Handling Instructions
1 Oil filler cap
2 Oil gauge
On a level surface, check the oil level is at
the middle of the oil gauge. If necessary,
supply oil.
Check underneath the machine for oil
leakage.
Inspect the chain for damage, abnormal
wear and so on.
Inspect the cover for cracks, damage,
abnormal wear and so on.
Inspection of Universal Joint_001
1 Chain
2 Cover
Check the bottom of the machine for
leakage of liquid such as oil, water, etc.
Locate the leakage and identify the type of
liquid.
2
1
w39anh-001
Page 5-7