Move; Precautions For Traveling; Traveling Procedure - Baroness TDA1200 Owner's Operating Manual

Note:
Making the up-down handle one turn
increases/decreases the tine depth about 4
mm (0.16 in).
Adjust the depth referring the depth gauge
and the scale decal provided on both sides
of the attachment.
One scale corresponds to 10 mm (0.39 in).
When the tip of the depth gauge is at the
uppermost edge of the scale, it shows the
maximum depth of standard tine.
4. Tighten the right and left roller holding
fixtures.
A
4
3
2
Adjustment of Tine Depth_001
1 Up-down handle
2 Roller holding fixture
3 Depth gauge
4 Scale decal
A Shallow
B Deep

Move

Precautions for Traveling

Warning
The traveling speed for a tractor with the
attachment installed should be 10 km/h or
less.
Especially when traveling up and down
slopes, be sure to travel at such a speed that
you can stop immediately for emergencies.

Move

1
B
F1934485
Handling Instructions
Warning
If the front of the tractor feels as if it lifts off the
ground on slopes, steering ability may
become affected or the machine may roll over.
Add genuine balance weights from the tractor
manufacturer to the front part of the tractor
according to the tractor's owner's manual.
Important
If a tractor with the attachment installed
travels at maximum speed, the attachment will
be damaged by violent shaking.

Traveling Procedure

Warning
Do not rotate the PTO while traveling.
1. Start the engine of the tractor, and then
increase the engine speed.
2. Raise the attachment to the maximum
position by using the attachment up/down
lever (hydraulic lever) of the tractor.
3. Travel, driving slowly.
TDA1200・TDA1600
Page 5-9