Xerox CopyCentre 133 Supplementary Manual page 8

Quick Network Scanning Setup
Network scanning uses FTP or SMB protocols to transfer scanned documents on to a server or a client.
Templates and repositories (folders) need to be set up to enable network scanning. See the User Guide for
information about how to set up templates and repositories.
See also:
Quick Scan to FTP Setup
Quick Scan to SMB Setup
User Guide: Contains information on how to set up templates and repositories.
System Administrator Guide: Contains details about Network Scanning setup.
Prerequisites for Network Scanning Setup
1.
Confirm that an existing operational network utilizing TCP/IP is available.
2. Confirm that your transfer protocol (FTP/SMB) is configured correctly (see the
on page 8, or the Quick Scan to SMB Setup
3.
Repository (folder) needs to be created on the FTP or SMB server to hold the scanned document.
4.
Confirm that the following ports are enabled:
a.
TCP/IP Port
b.
FTP Client Port or SMB Port (depending on which protocol is used)
c. SNMP Port
d. SOAP Port
Data to Set Up Network Scanning
Templates are created via CentreWare
Internet Services or any other Xerox
Network Scanning Solutions.
Repositories are created via CentreWare
Internet Services or any other Xerox
Network Scanning Solutions.
Kerberos IP Address
on page 8: Contains information about setting up Scan to FTP.
on page 10: Contains information about setting up Scan to SMB.
on page 10).
Install
Requirement
Required
Required
Optional
Xerox WorkCentre
Comments
Refer to the User Guide, "CentreWare Internet
Services" for more information.
Refer to the User Guide, "CentreWare Internet
Services" for more information.
If Remote Authentication is required, then
Kerberos needs to be enabled.
®
Pro 123/128/133
6
Quick Network Scanning Setup
Quick Scan to FTP Setup