Using Relays - Omron WT30-CA2M Operation Manual

Using Relays

4-3 Using Relays
4-3-1 System Configuration Example
Frequency channel: 02
Node number: 99 (reserved for relay mode)
I/O signal input/output is not possible.
Number of relay stations: 1 max.
4-3-2 I/O Slave Station Settings
1,2,3...
4-3-3 Relay Station Settings
1,2,3...
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Serial Master Station
Frequency channel: 02
WT 30-
M01 -FL
K
Function setting switch: Bit 3 ON (relay function enabled)
Relay station
WT 30-
SID 16
I/O Slave Station
Frequency channel: 02
WT 30-
SID 16
Node number: 01
1. Set the node setting switch to 01.
W NODE
X10 X1
2. Set the channel setting switch. (Example: 02)
W CH
Setting range: 01 to 34, 51 to 83
X10
X1
1. Set the node setting switch to 99. Setting the node number to 99 reserves
the WT30 Terminal for use as a Relay Station only.
W NODE
X10 X1
2. Set the channel setting switch. (Example: 02)
W CH
Setting range: 01 to 34, 51 to 83
X10
X1
Section 4-3
63