Scan List Enabled/Disabled Mode - Omron WT30-CA2M Operation Manual

Function Setting Switch
3-6-3

Scan List Enabled/Disabled Mode

Scan List Disabled Mode
52
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Set the special function switch as follows:
ENTER
ON
OFF → ON → OFF
OFF
Confirm scan list registration using the RSSI display. The RSSI's green indica-
tors will flash 4 or 5 times to indicate that the operation has been completed.
The scan list enabled/disabled mode is set during RUN mode. In scan list
enabled mode, communications are performed with the specified, registered
communications partners. In scan list disabled mode, communications are
performed without registering any communications partners.
1. Scan list registration is not required: Use scan list disabled mode
2. Scan list registration without serial number check is required: Use scan list
enabled mode
3. Scan list registration with serial number check is required: Use scan list
enabled mode
In scan list disabled mode, communications are performed without registering
I/O Slave Stations starting from the node number 1 specified at the Serial
Master Station up to the specified number of nodes. Scan list registration is
not required in this mode, and I/O Slave Stations can be added and replaced
using switch settings only. I/O Slave Stations are detected again, however,
when a power interruption occurs at the Serial Master Station. Therefore, the
Serial Master Stations cannot determine whether I/O Slave Stations have
been changed (connecting a different model to the same node number). Even
if only the power to the I/O Slave Station has been interrupted, a different sta-
tion will not be detected.
RSSI display: Green indicators flashing
Section 3-6