Omron WT30-CA2M Operation Manual page 7

Approved Standards
Applicable Countries
Conformance to EN Standards
Conformance to UL Standards
FCC Notice
Caution
Notice
iv
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Conforming Wireless Standards:
Japan: ARIB STD-T66
USA: FCC part 15.247
Europe: EN 300 440-2
Conforming Safety Standards: UL508 (Listing)
Conforming EMC Standards: EN 301 489-3
Conforming EMF Standards: EN 50371
This product has been approved for wireless standards in the countries listed
below. This product cannot be used in any other countries.
Austria, Belgium, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungry, Iceland, Ireland, Italy, Japan, Latvia,
Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Slova-
kia, Slovenia, Spain, Sweden, Switzerland, UK, USA
Use a DC power line less than 3 m to conform to EN standards. If a power line
of 3 m or longer is required, extend the length at the Switching Power Supply's
primary side (i.e., the AC power line).
Always use a Class 2 power supply to conform to UL standards.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful interfer-
ence, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
To ensure that the WLAN transmitter complies with current FCC regulations
limiting both maximum RF output power and human exposure to radio fre-
quency radiation, a separation distance of at least 20 cm must be maintained
between the Unit's antenna and the body of the user and any nearby persons
at all times and in all applications and uses.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
EN 60950-1
EN 301 489-17