Setting The Displayport1 Version; Setting The Dvi Refresh Rate - Eizo RadiForce GX560 Installation Manual

5-5. Setting the DisplayPort1 Version

You can set the DisplayPort1 version.
Attention
• To use a daisy-chain connection, set the version to "1.2".
• When a PC is connected via the DisplayPort connector, the DisplayPort version may differ depending on the PC,
and consequently the screen may not appear. In this case, try changing the following settings.
• DisplayPort2 is locked in version "1.1".
Procedure
1. Select to turn off the monitor.
2. While touching the leftmost switch (
monitor.
3. Select "Signal Format" from "Administrator Settings", then select
4. Select "DisplayPort1", then
5. Select "Version", then
6. Select "1.1" or "1.2", then select
7. Select "Apply", and then select

5-6. Setting the DVI Refresh Rate

Set the DVI refresh rate (screen update frequency) to suit your environment.
Procedure
1. Select to turn off the monitor.
2. While touching the leftmost switch (
monitor.
3. Select "Signal Format" from "Administrator Settings", then select
4. Select "DVI", then
5. Select "Preferred Refresh Rate", then
6. Select "Low" or "High", then select
Setting
Low
High
7. Select "Apply", and then select
), touch
.
.
.
.
), touch
.
.
.
Refresh rate
25 Hz
50 Hz
.
for more than two seconds to turn on the
.
for more than two seconds to turn on the
.
Chapter 5 Configuring Monitor Settings
19