Speed Sensor - Schwinn IC7 Service Manual

18. Put the Drive Belt (N) around the edge of the Drive Pulley (O). Slowly
turn the Drive Pulley and carefully walk the Drive Belt onto the Drive
Pulley. Make sure the Drive Belt is aligned on the Flywheel pulley (L1) and
Drive Pulley.
Flywheel (L).
19. Reassembly is the reverse procedure.
NOTICE: Do not crimp any cables. Install the Flywheel Tensioners
(G) at the position that you recorded in step 10. Make
sure the Flywheel (L) can turn easily. Verify that the
Speed Sensor (M) and Speed Sensor Magnet (P) on the
Flywheel do not touch.
Installation does not require the use of the crank puller. Be sure the Crank
Arms are connected at 180° from each other.
20. Make sure that the Drive Belt tension is correct. Refer to the "Adjust
the Belt Tension" procedure.
21. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully
assembled and inspected for correct
performance in accordance with the Owner's
Manual.
48
M
P