Table of Contents
Advertisement
41
After driving for about 8 km / 5 miles, bring
the car to a safe and suitable area and
engage the electrical parking brake. Take
the compressor and restore the pressure
using the black inflation hose (L) fig. 41.
If the pressure shown is higher than
1.8 bar( 26 psi), restore the pressure and
drive safely to a Jeep Dealership as soon as
possible. If, however, the pressure is lower
than 1.8 bar (26 psi), do not resume driving
and contact a Jeep Dealership.
Inflation procedure
Proceed as follows:
stop the car safely, as described above,
and engage the electric parking brake
take out the black inflation hose
(L) fig. 41 and screw it firmly onto the
tyre valve
Press the air (M) fig. 41 of release button to
adjust any tyre overpressure.
32
OPT2 KIT DESCRIPTION
The TireKit comprises:
(A) fig. 42 Pressure gauge
(B) Instruction label
(C) ON-OFF switch
J0A2430
42
43
(D) fig. 43 Air pipe
(E) Deflating button
(F) 12 V power supply cable/plug
44
(G) fig. 44Cap for sealant bottle
(H) Sealant bottle and expiry date
(I) Speed label
J0A5072
45
The kit is comprised of a compressor (B)
fig. 45 and a cartridge (A) containing the
J0A5084
sealant and an adhesive label (C) with the
writing "Max 80 km/h / 50 MPH", to be
applied in a visible position (e.g. dashboard)
after repairing the tyre.
J0A5085
J0A5086
Advertisement
Table of Contents
