Table of Contents
Advertisement
Repair procedure
Proceed as follows:
take the kit, detach the speed limit
sticker (I) fig. 44 and apply it in a clearly
visible position fig. 46
open the cap on the compressor,
engage the cartridge and turn a quarter
turn clockwise, fig. 47
remove the cap from the tyre valve and
screw the black compressor tube onto
the valve
46
47
make sure that the ON/OFF button is in
the off position (button in position 0)
insert the electrical connector fig. 48
into the 12V socket on the car
activate the compressor setting the ON-
OFF button, fig. 49, to the on position
(button in position I)
48
J0A5088
49
When the prescribed pressure
indicated in the Owner Handbook
("Wheels" chapter, section "Technical
Specifications") or on the specific label
appears on the pressure gauge, turn off
the compressor by moving the button to
J0A5089
the OFF position (O)
50
If the pressure gauge indicates a pressure
lower than 2.0 bar / 29 psi within 10
minutes of starting the compressor,
turn off the compressor, disconnect the
black compressor tube from the tyre
J0A5090
valve, unscrew the cartridge from the
compressor by turning it a quarter turn
anticlockwise and lift it out. Move the car
by approximately 10 metres to allow the
distribution of the sealant.
J0A5091
51
J0A5092
J0A5093
33
Advertisement
Table of Contents
