Opt1 Kit Description - Jeep RENEGADE 2023 Quick Manual

OPT1 KIT DESCRIPTION

The TireKit fig. 38 comprises:
 one (cartridge A ) containing sealant
and fitted with: transparent tube for
injecting the sealant and sticker (C with
the wording MAX 80 km/h / 50 mph to
be placed in a clearly visible position
(e.g. on the dashboard) after repairing
the tyre
 one compressor (B)
 a pair of gloves located in the hose
compartment of the cartridge (D)
38
Repair procedure
Proceed as follows:
 insert the cartridge (A) fig. 38
containing the sealant in the proper
compartment of the compressor (B),
pressing it down forcefully. Remove the
adhesive speed label (C) and apply it in
a visible position
 wear the gloves
 remove the cap from the tyre valve and
connect and screw the transparent tube
of the sealing fluid (D) fig. 38 onto the
valve. If a 250 ml cartridge is present
the housing of the transparent tube
is provided with a removable ring to
facilitate extraction
 make sure that the ON-OFF button
(F) fig. 39 is in the off position (button
not pressed)
39
 insert the electrical connector the 12V
power socket of the car and start the
J0A0955C
engine
 operate the compressor by pressing
the ON-OFF button (F) fig. 39.. When
the pressure gauge (G) reads the
prescribed pressure (see the "Rims
and tyres" chapter in the "Technical
Specifications" chapter of the online
Owner Handbook or the specific label)
turn off the compressor by pressing the
ON-OFF button again)
 disconnect the cartridge (A) fig. 40
from the compressor by pressing the
release button (H) fig. 40 and lifting the
cartridge upwards
40
If the pressure gauge (G) fig. 39 indicates
a pressure lower than 1.8 bar (26 psi)
15 minutes after starting the compressor,
switch off the compressor, disconnect the
sealing fluid tube (D) fig. 38 from the tyre
valve and remove the cartridge (A) from the
J0A8926
compressor .
Move the car by approximately 10 metres to
allow the distribution of the sealant.
Stop safely, engage the electric parking
brake and restore the pressure to the
prescribed value using the black inflation
pipe (L) fig. 41. If the pressure is still lower
than 1.8 bar (26 psi) within 15 minutes of
turning it on, do not resume driving and
contact a Jeep Dealership.
J0A8927
31