With Telnet - Agilent Technologies 1100 Series User Manual

With Telnet

Whenever a TCP/IP connection to the detector is possible (TCP/IP parameters
set by any method), the parameters may be altered by opening a Telnet
session.
1 Open the system (DOS) prompt window by clicking on Windows START
2 Type the following at the system (DOS) prompt:
Figure 18
Figure 19
1100 Series DAD and MWD User Manual
button and select "Run...". Type "cmd" and press OK.
c:\>telnet <IP address> or
c:\>telnet <host name>
Telnet - Starting a session
where <IP address> may be the assigned address from a Bootp cycle, a
configuration session with the Handheld Controller (G1323B), or the
default IP address (see
When the connection was established successfully, the detector responds
with the following:
A connection to the module is made
"Configuration Switches"
LAN Configuration
on page 34).
3
47